Clutch pedal sticking peugeot 206

I was in slow moving traffic and the clutch pedal started to feel loose at the bottom as I pressed it down and the car stalled a few times. Peugeot forums community. Unable to engage any gear, gear lever would not move.

Discovered that clutch pedal was flat to the floor and stuck in that position. Can you drive a car with a clutch pedal on the floor?

Warning: Do not attempt to start the engine and drive the vehicle with the clutch pedal stuck all the way to the floor.

You could damage the clutch, the clutch fork, or the transmission. I press the clutch pedal it makes intermittent clicking noises and the clutch does not disengage (change gears). The pedal loses tension.

TlcDriver points. After a few soft pumps it starts to work again for a while. I have to force it n then pump the pedal q. Don’t put the car into gear but push down the clutch pedal partway and listen out for any noises it makes. This sort of noise is usually associated with problems with the clutch release or throw-out bearings.

When the clutch is engaged (foot off the pedal ), the springs in the clutch press these three parts together so that the engine and the transmission are connected and spinning at the same speed.

When you press your foot on down on the clutch pedal, however, the springs pull the pressure plate away from the. About months ago for the first time, I slowed down at traffic lights and as I was gearing down I stepped on the clutch and it clicked loudly.

It was difficult to get the vehicle into gear, as the clutch was not fully disengaging and there was a ‘scraping’ noise emanating from the bell housing area, so a gearbox removal was advised and authorised. Press the accelerator pedal to the floor, Hold for seconds, Press the pedal to the floor, Turn the ignition off for one minute. Once the final step had been underaken the engine started promptly.

So there we have it – a full throttle pedal command restored! Search Fixya Browse Categories Answer Questions. Fast forward to last week when the pedal got very soft and ended up sticking to the floor a couple of times.

Bled the slave cylinder last night. Fluid coming out was very frothy and filled with tiny little air bubbles. Took us a while to get it bled out.

Does anyone have any idea what could be wrong with it? Also it often makes a clicking sound when i put the clutch down. Hi guys, Could anyone give me advice on a clutch pedal sticking on return? Its about inch from the top and seems to work fine otherwise.

I read somewhere this can be a worn ball on the cylinder but is this in the foot-well or gearbox? At the side of the clutch pedal on this vehicle is a spring assister.

At a certain ware point of the cluches life this spring would stop the peddle from returning to its upper position.

When i worked at peugeot we used to remove this spring assister and it would stop it from sticking. If you are in manchester i will come and. Occasionally, when you press the pedal you get a sort of clicking noise, sort of like a worn cog slipping a notch orand the result is the clutch does not disengage. Clutch Pedal Problem?

Depending on the age of your boxer van, older types are as follows, the clutch pedal in made from plastic and is retained by a circlip onto the pedal box and a linkage clip onto the clutch cable. SOURCE: clutch pedal stuck to the floor hi, there is one place you should check.

How can I fix this?