Applying vinyl wrap with soapy water

If you take the proper precautions and use the correct techniques, you can apply vinyl wrap smoothly and efficiently from home. How to apply wet wrap to vinyl? What is a vinyl yacht wrap? Apply indoors and away from sunlight.

Don’t install in high levels of humidity.

Store away from heat and at a vertical angle. Vinyl Installation Tips To gain a more in-depth look at how to install vinyl wraps to your vehicle, refer to Rviny’s wrap installation instructions. Begin by spraying the surface with the wetting solution. Next, remove the vinyl from the backing paper by peeling it back from one.

A method using soapy water to easily apply vinyl car stickers etc. Fast – Applying vinyl wrap is a very quick process, and depending on the size of the superyacht can usually be done in a few days.

That means further cost reductions due to a cut down on shipyard time.

Easy maintenance - A vinyl yacht wrap is easy to care for. We show you the way we found to be easy. After cleaning with soapy water, rinse thoroughly with water until no soap or residue remains.

There are many different methods. Do not use window-cleaning products. They may leave a residue behin making your sticker cling. Thoroughly wet the surface with RapidTac or soapy water.

Peel a few inches of vinyl from the backing paper, and adhere that section off the edge of the surface (in this case to the table). Pulling tension on the vinyl, begin applying to on the surface by removing the backing paper and laying it down. Follow the roll with a squeegee to keep the vinyl smooth.

If wrinkles occur, peel the vinyl. For a wrap to be installed properly, the extremeties of the wrap must be completely installed on the panel. Any loose or floating material not properly adhered to the panel or acting as a flap to exposed air will ruin the integrity of that edge or corner. To seal an edge, make sure you heat and press the film into place ( we recommend degree).

A trick we use is having a squeegee guide the. The soap and water dries in a few minutes and the decal is firmly affixed.

This method would also work with window tint gels. The easiest way to apply vinyl is to position in place, then peel back a small section of the vinyl and fold the backing paper under. You can now stick the leading edge down.

Now, whilst pulling the backing paper off squeegee the vinyl down with smooth actions. The third thing to watch is application fluid.

Many people like to use soap and water for their application flui and this is OK. However, you need to make sure the soap being used does not contain any perfumes or lotions.

These can act as a contaminant and weaken the graphic adhesion. Also, more is NOT always better. If the instructions say. Soapy water works for sure, but again only a drop or two of soap.

I have used windex or soap and water in the past, but it does take a while to dry. It is great for multi-layer vinyl applications such as my Cap because it sets up much quicker once you squeegee the air out.

I noticed I did not have as many trapped air bubbles with the "Rapid.